KOHLER T25740-4-BN TIPS Tvåhandtagsmonterad badkranartrim, levande borstad nickel Tvåhandtag vibrerande borstad nickel

Brand:Kohler

3.1/5

7360.72

PRODUKTBESKRIVNING Frigidaire Control Board och klocka av hög kvalitet (316207510) övervakar temperaturen och styr ugnsvärmen. Styrkortet och klockan har en elektronisk klocka/timerdisplay och ersätter 316557510. Var medveten om att det rekommenderas att använda säkerhetsutrustning och att koppla bort apparaten från alla verktyg före service eller reparation. Se din bruksanvisning för att bekräfta artikelnummer och för instruktioner eftersom vissa reparationer kräver en utbildad servicetekniker för att slutföra. FRÅN TILLVERKAREN Detta är en äkta reservdel. Modellnumret och namnet för följande artikel är: Ugnsstyrkort 316207510 Frigidaire kretskortstimer

Trim endast; kräver ventil för att slutföra installationen (säljs separat). Däckfäste. Tre hål. KOHLER yta motstår korrosion och matning. Premium metallkonstruktion för hållbarhet och tillförlitlighet. Koordinerar andra produkter i tipssamlingen. 10,0 gpm (3,8 lpm) maximal flödeshastighet vid 45 psi (3,1 bar). 7-7/16 tum (189 mm) räckvidd. Två spakhandtag ger separat kontroll av varmt och kallt vatten.
Brand Kohler
Color Vibrant Brushed Nickel
Finish Type Brushed
Handle Type Lever
Included Components Deck-Mount Bath Faucet Trim
Installation Method Centerset
Material Brass
Mounting Type Deck Mount
Number of Handles 2
Style Two-Handle

3.1

6 Review
5 Star
45
4 Star
30
3 Star
15
2 Star
0
1 Star
10

Skriv din recension

Din e-post kommer inte att publiceras. Alla obligatoriska fält är markerade med*

Scritto da: Bongu
Beautiful Hardaware and install. ***Not for an average DIY person***
First, the item I received was NOT new. The original seal was broken and shipping tape closed the box. I am not very happy about that. The parts all seemed to be in the box, but the instructions were super basic. I have a lot of experience replacing plumbing fixtures, so I was able to get this installed by myself. I cussed and cursed due to the ridiculously tight tolerance of the valve assembly pipes and the under deck clamp. The design of the under deck clamp was also ridiculous. The studs were 3.5 inches long, and the fasteners that went over the studs were over 2 inches long. The part that really set me off was the fact there was no connection provided to go from the mixed output to the diverter assembly. I had to create this myself. This is due to one of two things:. It could have been a casualty of being an open box and the parts were missing, or it could have been like this from the factory with this connection left up to the installer to figure out. Either way, unacceptable. The installation required soldering and using special adapters because the hot and cold supply lines are 1/2 inch OD instead of 1/2 inch ID. The fittings are way different and I had to go to a specialist store to get the right ones. I will say the final installation looks great, and it scored a 100 with the WAF. I would only recommend this product if you are mechanically inclined and have top notch soldering skills.
Scritto da: Pamela Jordan
difficult to install. I hired a plumber and it was difficult..
Product was used in private home in the owner's bathroom.
Scritto da: Woody
Great faucet except...
Purchased 3 of these in brushed nickel for bathroom remodels. Nice finsh, easy installation. Only drawback is that they water spot and with the flat handle it is disappointing to have to continually wipe off. Expected more considering the price.
Scritto da: Bernard
Nice faucet, but perhaps too shiny.
We got this faucet in the shiny chrome version rather than the brushed look. While it looks great when clean and dry, we have found that it must be wiped off after almost every use to keep it looking good, since water tends to splash on it when it is used. Otherwise it works just fine.
Scritto da: Alice Watkins
New Update
Quiet and easy to use
Scritto da: Kelley Jordison
Nearly impossible to install
The most impossible faucet to install!!! Do not buy. The inexpensive brands have easy connections to water supply lines. You have to solder on connections for your water lines with this faucet to 3/8” copper lines!!! Ugh. Absolute nightmare. Then there are 3 mounting bolts you need to fasten and there isn’t enough space to get the nuts on.

Relaterade produkter

Upptäck vårt internationella nätverk

Vi skickar till 28 länder, över 200 000 produkter. Håll dig uppdaterad, prenumerera på nyhetsbrevet.

Array