Delta kran RP6346SS kärlskål gallersil, rostfri, 8 000 L x 7 400 W x 3 500 H

Name: Delta kran RP6346SS kärlskål gallersil, rostfri, 8 000 L x 7 400 W x 3 500 H
Brand: DELTA FAUCET
SKU: 0034449666640
Price: 1114.66 SEK
Availability: InStock

Brand:DELTA FAUCET

3.3/5

€
1114.66

Från varumärket: Delta kran. Med bräddavloppshål - För användning med toalettsänkor med inbyggda bräddavloppshål. För fartygssänkeapplikationer. Gallersil med bräddavlopp.

Belopp

Lägg till i kundvagn Köp nu

EAN: 0034449666640

Kategorier Verkyg & hemförbättring, Köks- och badinredningar, Badrumsinredning, Commercial Bathroom Sink Faucets, Touch On kranar,

Från varumärket: Delta kran. Med bräddavloppshål - För användning med toalettsänkor med inbyggda bräddavloppshål. För fartygssänkeapplikationer. Gallersil med bräddavlopp.

Batteries Included?	‎No
Batteries Required?	‎No
Brand	DELTA FAUCET
Brand	‎DELTA FAUCET
Color	Stainless
Color	‎Stainless
Customer Reviews	4.3 4.3 out of 5 stars 4 ratings 4.3 out of 5 stars
Finish	‎Brushed
Finish Type	Brushed
Finish Type	‎Brushed
Handle Type	Lever
Handle Type	‎Lever
Included Components	Strainer
Included Components	‎Strainer
Installation Method	Vessel
Installation Method	‎Vessel
Is Discontinued By Manufacturer	‎No
Item Dimensions LxWxH	3 x 3 x 6 inches
Item Dimensions LxWxH	‎3 x 3 x 6 inches
Item model number	‎RP6346SS
Item Package Quantity	‎1
Item Weight	‎13 ounces
Manufacturer	‎Delta Faucet
Mounting Type	Deck Mount
Mounting Type	‎Deck Mount
Part Number	‎RP6346SS
Product Dimensions	‎3 x 3 x 6 inches
Size	‎8.000"L x 7.400"W x 3.500"H
Warranty Description	‎Faucet and Finish Lifetime Limited Warranty

5 Star

4 Star

3 Star

2 Star

1 Star

Skriv din recension

Din e-post kommer inte att publiceras. Alla obligatoriska fält är markerade med^*

Ditt betyg

Scritto da: LMH

Tricky installation, poor fit in the sink drain

This drain has the feel of quality and good materials but it was difficult to install. The drain is very flat whereas the sink's drain section has a little curve to it, so it was hard to get it to set in properly, took a good amount of plumber's putty (which is what Delta advised to use). Some other grid drains I looked at are in one piece and you can put the whole thing in from the top, but with this one they are separate and you must screw the flange and drain pipe together through the sink. This is difficult, the upper flange piece being a very short section and difficult to get a good hold on while you are trying to screw the lower section up into it. I finally wrapped some small needle-nose pliers with padding and put them through the holes and that worked well to keep the flange from spinning. It was also difficult to tighten the nut underneath the sink without the drain wanting to cock off to one side since the flange didn't fit into the sink drain very well. Finally, the rubber washer did not seal well against the bottom of my sink so I had to use plumber's putty, which I'm not happy about. I did finally get it installed without leaks, though, and I do like it now that it's installed. But I have to say, the old drain I took out was a much better fit both in the sink and below it and never had any problems with leaking. I'm not sure I really trust this one yet.

Scritto da: SME

Four Stars

Easy install.. Matches the faucet perfectly...