BOSCH BL2191 1 in. x 6 tum. Svartoxidborr med reducerat skaft

Name: BOSCH BL2191 1 in. x 6 tum. Svartoxidborr med reducerat skaft
Brand: BOSCH
SKU: 0000346332360
Price: 712.25 SEK
Availability: InStock

Brand:BOSCH

3.2/5

€
712.25

För användning i stål, koppar, aluminium, mässing, ek, lönn, MDF, furu, PVC, polykarbonat, akryl, ABS, nylon och kompositmaterial. Finns i jobblängd, stubbig längd, förlängd längd (flygplan), 1/2 In. reducerat skaft (Silver och Deming). Enklare borrning, minskad värme och förlängd livslängd på borrkronan. Håller 50 procent längre än snabbstål. Hastighetsspiraldesign för tre gånger snabbare borrning än standardborrkronor.

Belopp

Lägg till i kundvagn Köp nu

EAN: 0000346332360

Kategorier El & handverktyg, Elverktyg & Tillbehör, Elektriska borrmaskiner Delar & Tillbehör, Twistbits, Borrbits, Jobber Drill Bits,

Brand	BOSCH
Finish Type	Black Oxide
Material	Brass
Shank Type	Straight
Tool Flute Type	Spiral

5 Star

4 Star

3 Star

2 Star

1 Star

Skriv din recension

Din e-post kommer inte att publiceras. Alla obligatoriska fält är markerade med^*

Ditt betyg

Scritto da: Jack

Heavy duty drilling in steel

Yes, does a fantastic job, even in hardened cast-iron. I found that a 350 rpm setting on your heavy duty drill press is perfect.

Scritto da: opinions are like A_ _ holes

sharp

this is a good quality drill bit. it cuts great and seems to stay sharp. i always use cutting oil so im sure that helps as well

Scritto da: Damon

Just as the doctor ordered

Needed a 1" drill bit to drill through Robinson's decking after pilot hole. Works great.

Scritto da: WBS

Not for heavy duty use

I knew it was HSS black oxide and not Cobalt but I only needed to widen 8 holes from 7/8 inch to 1 inch in 1/4 hard steel. Got four done but last one was extremely hard to do. Not sure now whether the bit will handle soft metal.

Scritto da: Paul Vitolins

Cuts like a champ. As one would expect from Bosch

Cuts well and stays sharp! Very satisfied. Thanks!

Scritto da: notme

so far so good

drilled a few holes with it, only thing I don't like is it would be better if the shank had 3 flats.....

Scritto da: Ronny Dwiputra

CAN DRILL 1" THICK OF STEEL

So I used this drill bit with some lubricant to extend the hole of my trailer hitch from 3/4" to 1". It's like drilling 1"-1-1/2" thick of steel. I took me like 20 mins of drilling, but it works, even just with my cheap RYOBI drill.